







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Toto Bathroom Remodeling in Boulder City: What to Know First
Toto bathroom remodeling in Boulder City typically runs $9,000 – $28,000, with most full-room projects finished in two to four weeks once materials are on site. The number you see on your written estimate is the number you pay, and every job is backed by our 730-Day Done Right Promise. We’re an independent Toto service provider, not affiliated with or authorized by Toto, and we’ve built our remodeling work around what Toto fixtures actually need to perform. If you own a Toto toilet, washlet, or tub and you’re weighing a repair against a full remodel, we’ll give you a straight answer over the phone. Call (888) 282-1693 to schedule a free estimate.

How Toto Products Fail – and How We Fix Them

Toto builds some of the most reliable bathroom fixtures on the market, but nothing is indestructible, and the failure modes we see on Toto jobs are different from the ones we see on builder-grade brands. Here’s what we actually run into in Boulder City homes:
- Washlet control boards and inlet valves. The Washlet line – C100 through C200 and the high-end S7A – is where we get the most calls. When the bidet seat stops spraying or throws an error code, the culprit is usually a scaled inlet valve or a control board that’s taken on moisture, not a failed motor. We diagnose the valve and board first, because swapping a $900 seat assembly when a valve screen is clogged is money you don’t need to spend. On remodel jobs we replace the power supply and backflow protection while the wall is open, which is far cheaper than fishing new runs later.
- Fill valves and flappers on the Drake and Eco Drake. The Drake II and Eco Drake are everywhere in Boulder City, and their G-Max fill valves are genuinely good – until hard water and mineral scale build up the flapper seat. The symptom people describe is a “ghost flush” in the middle of the night. It’s almost always a worn flapper, not a cracked tank. We replace with Toto OEM parts because aftermarket flappers in these models fit poorly and can double water use.
- Wax ring and flange failures on the Ultramax II. The Ultramax II is a low-profile one-piece, and when it’s set on an older cast-iron flange from the 1970s and 1980s, the wax ring compresses unevenly. You get a slow leak at the base that rots the subfloor before anyone notices. In a remodel we set the flange properly and inspect the subfloor before the new tile goes down.
- Tub and shower valve trim leaks on the connector suites. Toto shower trims like the Connector series use cartridges that can pit in our desert water. By the time a homeowner calls, the wall behind the valve usually has soft drywall. We open that wall during a remodel, replace the cartridge and rough-in if needed, and re-tile with proper waterproofing, which most one-visit repairs skip.
- Seat and hinge wear on the Aquia and Vespin II. The soft-close seat mechanisms on these lines wear out in five to seven years – the seat slides and won’t stay up. It looks minor but it’s the number-one reason Toto owners start thinking about a remodel in the first place. If the rest of the bath is dated, we’ll show you options for a full refresh versus just a seat swap.
The difference on a Toto job isn’t that the fixtures fail more often – they fail less. It’s that parts and service decisions matter more, because the products are worth keeping and repairing rather than ripping out.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Our Toto Bathroom Remodeling Process
Every Toto remodel we do in Boulder City follows the same sequence, whether it’s a single vanity refresh or a full room gut:
- 1
Free on-site assessment. We walk the room, document every Toto model number (usually stamped under the tank lid or on the flush tower), and check what’s actually failing versus what’s aging out gracefully.
- 2
Repair-versus-replace decision in writing. For each Toto fixture we tell you plainly whether it’s worth keeping. A Washlet that needs a ol80 valve gets a valve. A 20-year-old Ultramax II on a questionable flange gets flagged for replacement – and we show you why.
- 3
OEM versus quality aftermarket parts call. We recommend Toto OEM parts for toilets and washlets whenever they’re available, because fit and water use are dialed in at the factory. For trim and hardware we’ll tell you where a quality aftermarket part is genuinely fine and where it isn’t.
- 4
Rough-in and waterproofing. New valve rough-ins, backflow protection, and proper substrate and membrane waterproofing so the tile and the Toto fixtures both last.
- 5
Install and pressure test. Every connection gets tested before the walls close and again before final walkthrough. Flush performance, spray pressure, and seals get checked with you in the room.
- 6
Cleanup and the 730-Day Done Right Promise. We haul the debris, leave the room clean, and if anything we installed isn’t right for two years, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Toto Bathroom Remodeling Costs in Boulder City

Here’s what real Toto projects run in the Boulder City market. These are written line-item ranges from our upfront pricing model – not ballparks.
| Project | Typical Range |
|---|---|
| Full bathroom remodel (including Toto fixture repair or replacement) | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
What moves the price: whether the rough-in plumbing has to be relocated, how much waterproofing and substrate work the existing walls need, and whether you’re keeping your Toto fixtures or upgrading them. A washlet that needs a new supply line and backflow protection adds a modest amount in labor but saves you a wall tear-out later. Tile selection and vanity footprint are the two biggest line items homeowners control. Call (888) 282-1693 for a free written estimate – we give you the full line-item breakdown before any work starts.
Why Boulder City Homeowners Call Groundwork Construction Co. of Boulder City for Toto Work
We’ve been in business since 2014 and have been serving local communities for over 42 years, and the reason Toto owners call us is straightforward: our technicians have up to 12 years of experience and they know how these fixtures are built. When a Washlet throws an error code, we’ve probably seen the same one this month. When a Drake II won’t stop running, we know to check the flapper before we suggest anything bigger.
Calls are answered by a live person, 24/7 – no voicemail black holes. Every technician is background-checked and arrives in uniform. And every project is covered by the 730-Day Done Right Promise, which is one of the longest workmanship guarantees in the residential construction space. If something we installed isn’t right, we make it right.
We also work across a curated set of brand partners – KraftMaid and Kohler for the rest of the bath, GAF and PGT for the rest of the home – so you’re not hiring five contractors to finish one job. From foundation to finish line, it’s one call. We offer $1,000 off projects over $10,000, 0% financing for 18 months, and a free project estimate and design consult so you can price the job before you commit.
FAQs

Not if the fixtures themselves aren’t damaged or altered improperly. Toto’s warranty generally covers manufacturing defects, not installation issues – so if a fixture fails because of a bad install, the warranty won’t cover it. We install to manufacturer spec and document everything so your coverage stays intact. Call (888) 282-1693 with your model numbers and we’ll talk through what applies.
Usually repair. A Drake II or Ultramax II that’s failing on a fill valve or flapper is a $150-$300 fix and has another decade in it. We only recommend replacement when the flange or subfloor is compromised or the fixture is genuinely at end of life. We’ll tell you which one it is when we see it – free estimate, no pressure.
For most current and recent lines, yes – Toto OEM parts are available through dealers, and we source them when the fit matters. Some older discontinued models require aftermarket equivalents, and we’ll tell you honestly when that’s the case rather than guessing. Call (888) 282-1693 for a parts check on your specific model.
Most full bathroom remodels take two to four weeks from start to final walkthrough, depending on material lead times and how much rough-in work the room needs. Small remodels and vanity swaps can be finished in a few days. We give you a real schedule in writing before we start, not a moving target.
Absolutely – and we prefer it when the fixtures are healthy. Keeping the toilet and washlet means you’re paying for the work that actually improves the room rather than replacing products that still perform. We assess both during the free estimate and tell you what’s worth keeping. Call (888) 282-1693 to set that up.
Ready to talk through your Toto bathroom project? Call (888) 282-1693 for a free estimate and a written line-item quote. A live person answers 24/7, and we’ll give you the honest repair-versus-replace call before you spend a dollar.
Written by the team at Groundwork Construction Co. of Boulder City, serving Boulder City and nearby areas.












