







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Summerlin: What It Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Summerlin, NV runs $3,500 – $9,000 for new asphalt paving, while a full driveway replacement lands at $5,000 – $14,000 and a fresh seal coat costs $250 – $700. Most residential jobs finish in two to four working days, with the new surface ready for foot traffic the same evening and vehicles after 48 to 72 hours. Call (888) 282-1693 to schedule a free on-site estimate.
From Grading to Final Roll: How the Work Actually Moves

Asphalt is unforgiving about sequence. Skip a step and the failure shows up eighteen months later as a spiderweb of cracks down the middle of the drive. Here’s what the days actually look like on a Summerlin job.
Day 1: demolition and excavation. We strip the old surface down to the subgrade and haul it out. On most Summerlin lots that means 4 to 8 inches of material removed, depending on what’s underneath. This is the day you make your first real decision: do we keep the existing driveway footprint or widen it? Widening is cheap at this stage and expensive later.
Day 1 – 2: subgrade prep and compaction. The exposed soil gets graded to slope water away from the garage and house, then compacted in lifts. Caliche shows up under a fair number of west-side properties, and that changes the day. If the caliche layer is thick it may need mechanical breaking before proper compaction is possible. We’ll tell you on-site whether your subgrade is workable as-is.
Day 2: base course. We lay and compact 4 to 6 inches of crushed aggregate base. This step is invisible in the finished product and it’s the one that determines whether the asphalt holds up through ten summers. You’ll also confirm the final grade and drainage direction here, before anything permanent goes down.
Day 3: asphalt placement. Hot-mix asphalt arrives, gets spread to a 2 to 3 inch compacted thickness, and is rolled while it’s still workable. Residential driveways typically take one lift; heavier-traffic approaches may call for two. The crew finishes edges by hand where the drive meets the garage apron and the street.
Day 3 – 4: cure and seal. The surface cures for 48 to 72 hours before vehicles go on it. Seal coating waits: fresh asphalt needs months to cure fully before sealing, and we schedule that as a separate visit. During heavy summer heat we sometimes wait for a cooler morning pour to keep the mix workable.
Throughout, you’re working through our driveway & pavers service, and if you’re still deciding between materials the Driveway & Pavers hub lays out the full comparison. If the drive is one piece of a larger outdoor project, it often sits under Driveway & Pavers in Summerlin alongside other hardscape work.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Most of the decisions on an asphalt job happen before Day 1. Here’s what you’re picking between, and where each one pays off.
- New asphalt vs. resurfacing. Resurfacing (an overlay) is cheaper and faster, but it only works when the base is still sound. If the base has failed, an overlay just buys you a few more years before the same cracks return.
- Hot-mix vs. cold-patch. Cold-patch is a temporary repair product, not a driveway solution. For anything sizeable, insist on hot-mix placed and rolled on-site.
- Thickness. A 2-inch compacted lift suits most residential drives. A 3-inch lift costs more up front but handles heavier vehicles, longer drives, and summer heat better.
- Seal coat timing. Sealing too early traps moisture. Sealing too late lets UV and grit wear the surface. A first seal around 6 to 12 months out, then every 2 to 3 years, is the usual rhythm.
- Edge options. Rolled edges are standard and less expensive. A concrete or paver border adds a finished look and holds up better against edge erosion, and brands like Tremron and Unilock make border options that pair well with the Mediterranean and desert-modern facades common in Summerlin.
If you want the driveway to read as a feature instead of a utility, matching border material to your home’s existing hardscape is the move most Summerlin homeowners land on.
What Asphalt Driveways & Resurfacing Costs in Summerlin, NV

Asphalt paving in Summerlin runs $3,500 – $9,000 for a typical residential drive. A full replacement (demo, prep, new asphalt) sits at $5,000 – $14,000. Seal coating is $250 – $700 per application. What pushes a job toward the top of those ranges is almost always one of five things.
| Line item | Typical range in Summerlin |
|---|---|
| New asphalt paving | $3,500 – $9,000 |
| Full driveway replacement | $5,000 – $14,000 |
| Seal coat | $250 – $700 |
Square footage. A single-car drive and a three-car drive are different projects. Price scales with area, not with a flat number.
Base condition. Sound subgrade keeps the job in the low range. Failed base or heavy caliche adds breaking, hauling, and sometimes import fill.
Access. Narrow side yards, gate clearances, and tight turnarounds slow equipment and add labor. Gated ridge communities can require tighter scheduling around HOA access rules.
Material thickness and mix. A 3-inch lift and heavier-duty mix cost more than standard residential spec.
Drainage work. Regrading, adding a swale, or tying into an existing drainage line is a scope item that shows up in writing or it doesn’t get done.
Your written estimate should list demo, haul-off, subgrade prep, base course, asphalt thickness, edge treatment, and cleanup. What’s typically outside the estimate: seal coating (usually scheduled separately), landscape repair around the edges, and any drainage correction the site turns up after demolition. Upfront pricing, no surprises: the number you see is the number you pay, and every project carries the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Summerlin Homes Specifically Do to This Job
Summerlin’s housing stock runs from 1990s Mediterranean and Santa Barbara single-family homes in the older east-side villages to contemporary desert-modern builds on the newer west side. East-side drives in places like The Trails often sit on original 1990s pavement that’s now showing its age, and block-to-block the base condition varies wildly. The newest northwest subdivisions can sit on caliche that stops a standard trenching shovel cold, which is why two similar-looking driveways two streets apart can come back with bids thousands of dollars apart.
The climate does its own work. Summer temperatures bake the surface and drive thermal movement through the whole structure, while monsoon-season downpours test every slope and drainage decision. A driveway that sheds water properly handles both; one that ponds in a corner will crack from the bottom up. Active HOAs with strict design review also shape what goes in, especially when the driveway is visible from the street or touches a shared entry. We work in these communities regularly across Summerlin and ZIP 89135, and we build the drainage plan before we pour.
Serving Summerlin, NV – Our Local Coverage Area
We serve Summerlin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Summerlin

Most residential Asphalt Driveways & Resurfacing in Summerlin take two to four working days from demo to finished surface, plus a 48 to 72 hour wait before you park on it. Larger drives and jobs needing caliche breaking or drainage rework can stretch to a week. Call (888) 282-1693 for a timeline specific to your property.
HOA approval is usually required in Summerlin, and some properties need a permit depending on how the drive meets the street and whether drainage changes. We’ll tell you what your property needs during the estimate. Call (888) 282-1693 and we’ll walk through it.
Yes, when the base is sound. If the cracking is surface-level, an overlay is a real option. If the base has failed, resurfacing costs less today and costs more in a few years. We’ll show you the difference on-site so the decision is yours.
New asphalt paving runs $3,500 – $9,000, full replacement runs $5,000 – $14,000, and seal coating is $250 – $700. Size, base condition, access, and thickness are the factors that move the number. Call (888) 282-1693 for an exact quote; estimates are free.
Every asphalt driveway we install is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing.
Homeowners finishing a bigger outdoor project often pair this work with Chain Link Fence in Summerlin for property-line security, or with ADU Site Prep & Utilities in Summerlin when a detached unit is going in and the driveway and trenching need to be planned together.
Get a Free Asphalt Driveway Estimate in Summerlin
Call (888) 282-1693 for a free on-site estimate on Asphalt Driveways & Resurfacing in Summerlin. A live person answers around the clock, every day. On the visit we measure the drive, check the base and drainage, and hand you a written line-item quote with fixed pricing, so you know exactly what’s included before anything gets torn out.
Written by the team at Groundwork Construction Co.












