







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Enterprise, NV: What the Job Actually Involves
Asphalt Driveways & Resurfacing in Enterprise, NV usually means one of two jobs: a full new asphalt pour for a home that’s never had a hard-surface drive, or a mill-and-overlay resurfacing on a drive that’s cracked, sun-cooked, or potholed. Most residential pours here run 2 to 3 working days from demo to cure, and most resurfacing jobs land between $3,500 and $9,000 depending on square footage, base condition, and how much subgrade has to be rebuilt. Call (888) 282-1693 and we’ll walk your drive, check the base, and put a fixed number in writing before anything gets torn out.
How we run an asphalt job, stage by stage

Every asphalt driveway follows the same order of operations. What changes is how much prep your specific drive needs. Here’s the sequence we run, with real durations.
Stage 1: Site walk and base inspection (day 0)
We measure the drive, probe the subgrade, and check how water currently moves across it. In Enterprise’s caliche-heavy soils, this stage tells us whether the existing base is compactable or whether we’re looking at rock-breaking and hauling. You decide here whether you’re resurfacing the existing asphalt or going to a full replacement. This walk is free and takes about 30 to 45 minutes.
Stage 2: Demolition and excavation (day 1, morning)
If it’s a replacement, the old asphalt gets broken out and hauled off. Caliche hardpan under many south-valley lots is tough enough that excavation sometimes needs a breaker attachment rather than a plain bucket, which adds time but not surprise once we’ve probed the base. On a resurfacing job, this stage shrinks to milling the top inch or two and cleaning the surface.
Stage 3: Grading, base, and compaction (day 1, afternoon into day 2)
We cut the grade to drain away from the garage and the house, then lay and compact the aggregate base in lifts. Drainage is the whole ballgame on desert lots. A drive that ponds during a monsoon gully-washer will fail years early no matter how good the asphalt is. You approve the final slope before we pave.
Stage 4: Paving and rolling (day 2)
Hot-mix asphalt goes down, gets screeded to thickness, and is rolled for density while it’s still workable. Summer pours in Enterprise get scheduled at dawn to beat the heat, because asphalt that cools too fast won’t compact to the density we want. A typical two-car drive takes a few hours to place and roll.
Stage 5: Cure and striping (day 3 and beyond)
Fresh asphalt needs to cure before you drive on it. We keep traffic off it for 48 to 72 hours in cooler months, longer in the peak of summer when surface temps climb. Line striping, if you want it, goes down after cure. You get a walkthrough and the written workmanship guarantee at that point.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’re actually choosing between
Asphalt isn’t one product. These are the real decisions that shape both the price and how the drive holds up.
- Full replacement vs. overlay resurfacing. A full replacement tears out and rebuilds the base; an overlay mills the top and paves over the existing structure. Overlay is cheaper and faster but only lasts if the base beneath is still sound. We won’t overlay a drive with a failing subgrade, because it just transfers the cracks upward within a season or two.
- Asphalt thickness. Residential drives typically run 2 to 3 inches of compacted asphalt over the base. Going thicker costs more upfront but resists rutting and heat deformation better, which matters under Enterprise’s summer sun.
- Base depth and aggregate. A shallow base saves money and fails fast. On caliche lots we sometimes have to go deeper just to reach stable material, and that shows up in the quote honestly.
- Sealer schedule. Fresh asphalt wants a seal coat after it cures, then resealing every few years. We schedule the first seal as part of the job so you’re not chasing it later.
- Edge treatment and drainage. Concrete curbs, a channel drain, or a simple graded shoulder. On lots with tight side yards or steep fall to the street, this is the difference between a dry garage and a wet one.
If the drive is part of a bigger outdoor project, the wider scope lives on our Driveway & Pavers in Enterprise page.
What Asphalt Driveways & Resurfacing costs in Enterprise, NV

Plan on $3,500 to $9,000 for asphalt paving on a typical Enterprise residential drive, and $5,000 to $14,000 when the base has to be rebuilt as part of a full replacement. Resurfacing alone usually sits at the low-to-mid end of that paving range. Here’s what moves you toward one end or the other.
- Square footage. A single-car drive and a long RV pad are different jobs. Length and width drive material and labor more than anything else.
- Base condition. Sound base means an overlay and a lower number. Caliche, soft spots, or failed subgrade means excavation and rock-breaking, which pushes the job toward the high end.
- Drainage correction. Regrading, adding a drain, or reworking how water leaves the drive adds cost but prevents the callbacks that come from standing water.
- Access and haul-off. Tight side yards and long pulls to the street slow demo and hauling, and that time is real.
- Permits and dust control. Active-tract and recently-completed subdivisions in Enterprise often require dust-control measures and design review, and those get priced into the estimate rather than tacked on later.
Our written estimate breaks out demo, base, asphalt, drainage, and any permit or dust-control line item separately. What’s typically not included: landscape repair beyond the drive edge, and any changes you request after paving starts. We quote it upfront so there are no surprise change orders.
See the difference
Before
After
Before
After
Before
AfterWhat Enterprise homes specifically do to this job
Enterprise is one of the fastest-built-out master-planned suburbs in the south valley, and that shape shows up in every asphalt job. A huge share of the housing went up within a short window by a handful of big builders, so block after block runs the same assembly: wood-frame and stucco on slab, the same floor plans, the same builder-grade drive aprons and the same original asphalt that’s now hitting the end of its service life all at once. That repetition is useful for us, because we’ve seen the same failure modes on the same drives across 89139 again and again. It also means HOA architectural review is a real gate here. In active-tract and recently-completed subdivisions, design review and the Clark County/Enterprise-township approval chain govern work, so we handle the paperwork and keep the replacement within community standards on color, edge treatment, and dust control. Summer pours get scheduled at dawn to beat the heat, and monsoon-season drainage gets graded carefully on every lot. If you’re covering the wider property, homeowners often pair this with Chain Link Fence in Enterprise along the drive edge, or with ADU Site Prep & Utilities in Enterprise when a detached unit needs its own access.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Enterprise

A standard residential driveway takes 2 to 3 working days from demo to cure, with 48 to 72 hours of traffic-free curing after paving. Full replacements with heavy caliche excavation can push to 4 days. Call (888) 282-1693 for a timeline built around your specific drive.
Often yes, and it depends on your subdivision and whether the work touches the approach or right-of-way. Active-tract HOAs here also run design review, so we check both before the first shovel goes in and handle the approval chain for you.
No, if the base is what our site walk found. Upfront pricing, no surprises is how we operate: the number in your written estimate is the number you pay, with change orders only if you request something new mid-job. Call (888) 282-1693 for an exact quote.
Sometimes. If the base is sound and the cracks are surface-level, an overlay resurfacing saves time and money. If the subgrade has failed, an overlay just transfers the problem upward, and we’ll tell you straight which one your drive needs.
Every Groundwork Construction Co. project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. You get that in writing, and our technicians bring up to 12 years of experience to the job. Call (888) 282-1693 to schedule your free estimate.
Get a free on-site estimate for Asphalt Driveways & Resurfacing in Enterprise
We’ll walk your drive, check the base, and hand you a fixed, line-item price for Asphalt Driveways & Resurfacing in Enterprise, with permits and HOA review accounted for before we start. Call (888) 282-1693 and a live person answers, day or night. Free estimates, written numbers, no pressure. Our team covers Enterprise regularly, and our Driveway & Pavers service handles the wider scope when your project grows.
Written by the team at Groundwork Construction Co.












