







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Whitney, NV: What It Costs and How Long It Takes
A chain link fence in Whitney, NV typically runs $3,500 to $9,000 for most residential lots, with the average job landing around the middle of that range once you factor in gates and corner bracing. Most single-yard installs are measured and permitted in week one, then built in one to three days on site. For an exact number on your lot, call (888) 282-1693 and we’ll set up a free on-site estimate.
How a Chain Link Fence Goes In, Stage by Stage

Chain link looks simple from the street. Getting it right takes a set sequence, and the order matters more than most homeowners expect. Here’s how we run the job.
Stage 1: Walk the line and check the ground (day 1)
We walk the property line with you and mark corners, gates, and any spot that needs a pull or a jog. In Whitney we’re often working slab-on-grade lots with old patios, sheds, or a scraped-in dirt drive, so we check for buried concrete, irrigation lines, and old footings from a fence that came down years ago. You decide fence height, gate placement, and where the line meets your neighbor’s. Allow a couple of hours.
Stage 2: Call for utility locates
Before a single post hole is dug, the locate request goes in. This protects your water and sewer lines and any buried electrical running to a detached shop or well pump. It usually adds two to three business days to the calendar, and it’s non-negotiable. Skipping it is how a fence project becomes an emergency plumbing call.
Stage 3: Layout and set posts (day 2 to 3)
We string the line, space posts on 8-foot centers (closer on corners and gates), and auger the holes. Posts get set in concrete and need to cure before anything gets stretched, so this isn’t a step you rush. On a 150-foot run that’s roughly 20 posts, and you’ll want to know going in that the gate posts get a heavier concrete footing than the line posts because that’s where the load lives.
Stage 4: Rails, mesh, and tension
Top rail, tension bands, and the mesh get pulled and stretched. This is the part that decides whether the fence looks tight in five years or sags and waves. Corner and end posts get diagonal bracing. A gate gets its frame, hinges, and latch set. One long day for a typical yard.
Stage 5: Walk-through and cleanup
We walk the finished line with you, check every gate for swing and latch, confirm tension, and haul off leftover concrete bags and wire spools. We give you a written explanation of the fence and post placement for your records, since a future buyer or an insurance review will ask about it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Specs You’ll Actually Choose Between
Chain link isn’t one product. The choices below are the real swing factors between a fence that lasts 20 years and one that needs replacing in 8.
- Mesh height: 4-foot, 5-foot, and 6-foot are the common residential options. A 4-foot line is fine for a side-yard marker; a 6-foot line is what most Whitney homeowners want when the goal is containing a dog or keeping a shop yard closed off.
- Gauge (wire thickness): 11.5 gauge is the standard homeowner spec. 9 gauge is thicker and much more resistant to a dog hitting the line or a branch dragging across it, and it costs meaningfully more per linear foot. For a large acreage perimeter, 11.5 is often fine; for a dog run or a shop enclosure, go heavier.
- Coating: Galvanized steel is the budget option and will rust in spots over time, especially along the bottom rail where desert dust and monsoon splash collect. Vinyl-coated (color core) mesh adds cost but holds color, softens the look, and holds up in the sun. Bufftech is one of the names we work with on the coated side.
- Top rail and bracing: Standard top rail is 1-3/8 inch. On longer spans and windy corners, a heavier rail and a tension wire at the bottom make a visible difference within a season or two of monsoon gusts.
- Gate hardware: Hinges, latches, and a drop rod for double gates. This is where cheap jobs show first: hinges that bind after one summer of heat and a gate that drops. We spec hardware rated for the gate size, not whatever’s in the bin.
- Posts: Round or square. Square posts with slats give a more finished look and pair well with a privacy slat system if you want the chain link line screened off. Master Halco is a supplier we use for standard steel components.
What a Chain Link Fence Costs in Whitney, NV

Plan on $3,500 to $9,000 for a residential chain link fence in Whitney. That range holds most lots, but the specific number on your property is driven by five things. Get a written line-item estimate before you commit to anything.
| Line item | Typical Whitney range |
|---|---|
| Standard 4-5 ft galvanized chain link, installed | $3,500 – $6,500 |
| 6 ft galvanized with heavier mesh | $4,500 – $7,500 |
| Vinyl-coated / color-core mesh upgrade | Add $600 – $1,500 |
| Walk gate (installed with frame and hardware) | $400 – $900 |
| Drive gate, double | $900 – $2,000 |
| Old fence removal and haul-off | $300 – $800 |
| Clark County permit | Varies by scope |
What moves you to the low end vs the high end
- Linear feet and corners: More corners and jogs mean more posts and bracing. A straight 100-foot run is cheaper per foot than a 100-foot run with four turns.
- Old fence and concrete: Pulling out a welded-wire line and the old footings underneath it adds labor. Encountering a buried slab mid-dig adds more.
- Gates: Every gate is its own little structural job, and two gates can add over a thousand dollars to a job.
- Material grade: 9-gauge and coated mesh cost more upfront and last longer. That’s a real trade-off, not a sales pitch.
- Access: A line that runs behind a shop, along a shared drive, or into a back corner with no room for a truck and wheelbarrow slows everything down.
Your written estimate will spell out mesh gauge, height, coating, gate count and hardware, post spacing, and whether removal is included. What’s typically not included: utility relocation, coordinating with a neighbor on a shared boundary line, and any landscaping repair along the fence line. If you’re also considering a run of wood or vinyl on the same property, our Fence Installation in Whitney page covers the broader scope – or go straight to our Fence Installation service overview.
See the difference
Before
After
Before
After
Before
AfterWhy Whitney Is Different From Neighboring Cities for This Job
Whitney is unincorporated Clark County. That matters on the permit side: fence work here goes through Clark County building permits and county inspections, not a municipal building department. A contractor hopping between Whitney and Henderson or Las Vegas has to switch permit authorities job to job, and we do that routinely. Much of Whitney’s 89122 footprint is infill and redevelopment along Boulder Highway and the surrounding tracts, not fresh subdivision line drawing. That means our crews regularly hit old slab-on-grade lots where the fence line crosses a torn-out patio edge, a dead utility stub, or a mobile/manufactured home pad boundary. The housing stock is largely mid-century through 1970s-80s single-story stucco-and-slab, with mobile home pockets and small commercial strips mixed in, so a fence here often has to tie into an existing boundary that’s been patched or repoured at some point. Summer heat over 100°F and intense Mojave sun set the schedule: we pour post footings early morning and take cure time seriously, because concrete poured at 2 p.m. in July won’t hold a post the way it should. If your project grows into site work, grading, or utility runs, homeowners often pair this with ADU Site Prep & Utilities in Whitney.
We cover the full Whitney area and the surrounding east side. If a chain link run is one piece of a wider project that includes gates, headers, and hardware next to a shop or garage, Door Installation in Whitney is a common follow-on.
Serving Whitney, NV – Our Local Coverage Area
We serve Whitney and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Whitney

Most residential chain link installs in Whitney take one to three days on site once the utility locate has cleared, which typically adds two to three business days to the schedule. Small yards and straight runs go on the short end. Multi-corner lots with two gates and a demolition step run longer. Your written estimate will include a realistic calendar, not a sales number.
Fence permits in Whitney are issued through Clark County because the community is unincorporated, not through a city building department. Height, setback, and boundary requirements apply, and county inspection may be part of the job. We pull the county permit and walk the inspection with you. If you want an exact read on your lot before committing, call (888) 282-1693 and we’ll review it during the free estimate.
A residential chain link fence in Whitney runs $3,500 to $9,000, with most jobs in the middle of that range once gates are counted. Height, mesh gauge, coating, gate count, and removal of an old fence are the biggest swing factors. Upfront pricing is standard with us – the number in your written estimate is the number you pay. Call (888) 282-1693 for a free on-site quote.
Yes, in most cases. Post holes go in on the marked line only, and the truck and wheelbarrow work off the edge of the run. A gate that needs to stay usable during the work can be sequenced so you’re not locked out at any point. If your line crosses a driveway or a utility trench, we flag that during the walk-through so you know before work starts.
Our work is covered by the 730-Day Done Right Promise – if it isn’t done right, we make it right. That covers our installation and workmanship. Material warranties depend on the supplier and mesh spec you choose, and we’ll spell those out in writing before you sign anything. Our technicians have up to 12 years of experience installing fencing in this market.
Get a Free Chain Link Fence Estimate in Whitney
If you’re pricing a chain link fence for your Whitney lot, call (888) 282-1693 for a free on-site estimate. We’ll walk the line with you, check for buried concrete and old footings, talk through mesh gauge and gate placement, and leave you with a written line-item quote – no surprises, no pressure to sign on the spot. Our technicians are background-checked and arrive in uniform. Projects with us carry the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












