







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Boulder City, NV: What the Job Actually Involves
Paver driveways in Boulder City typically cost $7,000 – $18,000 and usually take 3 to 5 working days from demo to final compaction, depending on square footage and the condition of what’s underneath. The work is straightforward: tear out the old surface, build a base that won’t move, set the pavers, and lock them in. What separates a good paver driveway from a bad one is almost never the stone – it’s the base prep and the edge restraint. Call (888) 282-1693 to schedule a free on-site estimate.
How We Build a Paver Driveway, Stage by Stage

Every paver driveway follows the same basic sequence. The stages don’t change much from job to job. What changes is how much time each one takes, and that depends on what we find when we open up the existing drive.
Stage 1: Demo and Haul-Off (Day 1)
We remove the existing concrete, asphalt, or old pavers and haul it away the same day. On a standard two-car drive this runs 4 to 6 hours with a crew and a dumpster on site. This is where surprises show up – a cracked slab over expansive soil, a buried utility line, or a driveway poured directly on grade with no base at all. You’ll get a call before we go further if anything changes the price.
Stage 2: Excavation and Base Build (Days 1 – 2)
This is the stage that determines whether your driveway still looks flat in ten years. We excavate to depth – typically 6 to 10 inches depending on the paver thickness and expected load – then lay and compact the aggregate base in lifts. A 3-inch lift compacted properly beats an 8-inch lift dumped and rolled once. Expect this stage to take a full day on most Boulder City drives, longer if the soil needs stabilization.
Stage 3: Edge Restraint and Bedding Course (Day 2 – 3)
We set the edge restraint before any pavers go down. This is a decision point for you: concrete curb, aluminum edge, or a soldier-course border. Concrete curb holds best against desert soil movement. Aluminum edge is faster and cheaper. The bedding sand goes down next, screeded to grade. You’ll want to walk the layout with us before we set the first paver, because moving them after compaction is expensive.
Stage 4: Paver Installation and Cutting (Days 3 – 4)
Pavers go down in the pattern you selected, then we cut the field to your drive’s edges and around any curves. A double-car driveway at 400 – 600 square feet runs a day and a half to two days with two installers. This is also when we fit around your garage apron, any drainage channel, and the transition to the street.
Stage 5: Compaction, Polymeric Sand, and Final Walk (Day 5)
We compact the finished surface with a plate compactor, sweep polymeric sand into the joints, mist it, and let it cure. You get a walk-through with the crew lead and a written record of what was installed, which matters for your 730-Day Done Right Promise coverage. Most jobs are done in 3 to 5 working days. Larger circular drives and driveways with significant grade change run longer.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Paver Options You’ll Choose Between
You’ll make three real decisions on this job: the paver material and thickness, the pattern, and the edge treatment. Here’s what each one means in practice.
- Concrete pavers (interlocking) – $7,000 – $14,000 typical range. The most common choice for Boulder City driveways. They handle desert UV well, come in 60mm and 80mm thicknesses, and the 80mm is worth the extra cost if you park anything heavier than a passenger vehicle. Colors hold up well but do fade slightly over 10 – 15 years.
- Clay brick pavers – $10,000 – $18,000. Better colorfastness than concrete and a warmer look that suits the historic district’s Depression-era architecture. They cost 20 – 35% more than concrete and are heavier to lay. Worth it if curb appeal to a 1930s bungalow is the goal.
- Tumbled or antiqued finishes. A surface treatment that gives the paver an aged edge. Adds $0.50 – $1.50 per square foot. Pairs well with homes east of the historic district where the style is more relaxed, less formal.
- Running bond vs. herringbone pattern. Running bond is the standard, easiest to lay, and cheapest. Herringbone interlocks better under vehicle loads and resists shifting, but adds roughly 10 – 15% to labor. Worth it on a sloped drive.
- Edge restraint: concrete curb vs. aluminum. Concrete curb, roughly $8 – $14 per linear foot, is the durable choice in Boulder City’s shrink-swell soil. Aluminum edge, $4 – $8 per linear foot, is faster and fine for flat drives with light loads.
You’ll also want to settle the polymeric sand color and whether you want a drainage channel at the garage lip. Both are small decisions that cost little if made up front and cost real money if made after install.
What Paver Driveways Costs in Boulder City, NV

Paver driveway installation in Boulder City runs $7,000 – $18,000 for a typical residential drive. A single-car driveway at 250 – 300 square feet lands near the low end. A double-car or circular drive at 600 – 900 square feet sits at the high end, more if the pattern is herringbone or the material is clay brick.
Four things push the number up or down:
- Square footage and shape. Every curve and radius adds cutting time. A straight rectangular drive is the cheapest geometry you can build.
- Existing surface condition. A clean concrete slab over stable soil demos fast. A failed slab with no base underneath means full excavation and possibly a soil stabilization layer, which adds $2,000 – $4,000.
- Paver material and thickness. 60mm concrete vs. 80mm concrete vs. clay brick is the biggest single swing in material cost, roughly $4,000 – $6,000 across the range on a 600-square-foot drive.
- Grade and drainage. A drive that slopes toward the garage needs a channel drain and re-grading. That’s $800 – $2,000 depending on length and the drainage route.
- Permits and inspections. Boulder City has its own review process for exterior work, and any change to the driveway’s footprint that affects drainage or setback may need approval. We pull the permits and handle inspections as part of the project.
Your written estimate is line-item: demo, base, pavers, edge, polymeric sand, permit fees, and haul-off are each listed separately. Upfront pricing, no surprises. The number you see is the number you pay, unless you change the scope mid-job. The $1,000 off projects over $10,000 discount applies to most full paver driveway installations, and 0% financing for 18 months is available.
See the difference
Before
After
Before
After
Before
AfterWhat Boulder City Homes Specifically Do to This Job
Boulder City’s original townsite was built by the Bureau of Reclamation in 1931 to house Hoover Dam workers, and the historic district’s bungalows and modest 1930s-40s cottages carry construction methods that don’t exist in newer Henderson subdivisions. When we open up a driveway near the historic district, we’re often working around Depression-era site work – a narrow drive laid to 1930s car dimensions, or an original apron that was never designed for a modern vehicle’s turning radius. If your home is under historic preservation review, exterior alterations including driveway footprint changes can trigger a preservation review, and we plan the scope around that rather than getting surprised at inspection.
The other local factor is the ground itself. Boulder City sits at roughly 2,300 – 2,500 feet near Lake Mead, and the expansive desert soils here shrink and swell with moisture cycles. That movement is what cracks a poorly built paver base within a few seasons. We over-build the base depth on drives that show existing soil movement, and we use concrete edge restraint instead of aluminum where shrink-swell is a known issue. Summer installs, when highs hit 100 – 110°F, run early morning shifts so the crew works the cool hours and the polymeric sand sets properly.
Serving Boulder City, NV – Our Local Coverage Area
We serve Boulder City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Boulder City

Most paver driveways in Boulder City take 3 to 5 working days from demo to final walk-through. A 400-square-foot double-car drive with a simple pattern is typically 3 days; larger drives, herringbone patterns, or significant grading work push to 5. Call (888) 282-1693 for a timeline specific to your property.
Permits are typically required when the driveway footprint changes, when drainage or grading is altered, or when the home falls under historic preservation review. A straight replacement over the same footprint often doesn’t need a permit, but we confirm with Boulder City’s building department before starting. We pull any required permits and handle inspections – it’s part of the written estimate, not an add-on.
No, a paver driveway doesn’t require moving plumbing or structure in the vast majority of cases. The work stays above the foundation line. The one exception is when excavation for the base uncovers a buried utility or irrigation line, which is common in older historic district homes where original site plans are unavailable. We check the utility locates before day one and adjust the scope in writing if anything buried turns up.
Concrete pavers run roughly $15 – $24 per square foot installed in Boulder City, including base, edge, and polymeric sand. Clay brick runs $20 – $32 per square foot. Your final number depends on square footage, material, pattern, and whether the existing surface needs full excavation. Call (888) 282-1693 for an exact line-item quote – estimates are free.
Every paver driveway we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, for two full years after completion. That covers workmanship: base settlement, edge failure, and paver movement attributable to installation. Manufacturer warranties on the pavers themselves are separate and typically run longer. Call (888) 282-1693 and we’ll walk you through the full coverage before you sign anything.
Get a Free Paver Driveway Estimate in Boulder City
A free on-site estimate for paver driveways in Boulder City starts with a call to (888) 282-1693. A live person answers, 24/7 – no voicemail. We’ll schedule a site visit, measure the drive, check the base and drainage, and hand you a written line-item quote you can hold us to. If this is part of a full Driveway & Pavers in Boulder City project, we’ll scope both together. Our Driveway & Pavers service covers everything from a single drive to a whole-property hardscape, and our technicians have up to 12 years of experience with paver and hardscape installs.
A Note on Pairing This With Other Work
Homeowners in Boulder City often pair a paver driveway with Door Installation in Boulder City – a front entry upgrade alongside new curb appeal – or with Cabinets & Countertops in Boulder City if the driveway is part of a larger renovation. We use Driveway & Pavers standards on every job, and premium hardscape brands like Belgard are part of our material portfolio when the project calls for them. Background-checked, uniformed technicians on every job. From foundation to finish line, we handle the whole scope under one contract and one warranty.
Written by the team at Groundwork Construction Co.












