







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Spring Valley, NV: What It Costs and How Long It Takes
A chain link fence in Spring Valley typically runs $3,500 to $9,000 for a standard residential lot line, and most jobs are finished in two to three days once materials are on site. The number moves with linear footage, height, gate count and how much caliche the crew hits during trenching. Call (888) 282-1693 and we’ll walk your property, measure the run and put a written line-item quote in your hands – free, with no pressure and no vague ballpark.
How a Chain Link Fence Goes In, Stage by Stage

Chain link is a fast, honest build. The sequence doesn’t change much from job to job, but the timing does, and knowing the order helps you plan around it.
Stage 1: On-site measure and layout (day 1, about an hour)
We walk the property line with you, confirm where the fence actually needs to sit relative to the property corners, and flag anything buried – irrigation lines, low-voltage lighting, gas stubs, septic lids. You decide the run, the corner posts and where the gates land. If the line is ambiguous, this is the moment to pull the plat map, not after posts are set.
Stage 2: Call 811 and confirm the dig (1 to 3 business days before we start)
Nevada law requires a utility locate before any excavation. We schedule it, wait for the marks, and adjust post spacing around anything flagged. Skipping this step is how homeowners end up paying for a severed gas line, and we don’t do it.
Stage 3: Demo and trench (day 1, half a day)
If there’s an old fence, it comes out first – posts, fabric, concrete footings and all. Then we trench the post line. In much of Spring Valley this is where the day gets longer than planned: the caliche layer under the soil is dense enough to slow a trencher to a crawl, and we plan for rock-breaking equipment as a matter of course. You’ll see us commit real hours to this stage.
Stage 4: Posts, concrete and fabric (day 2, full day)
Terminal posts and corner posts go in first, set in concrete and left to cure. Line posts follow at consistent spacing. Once the concrete has set, we hang the top rail, stretch the fabric, and tie it off. Tensioning is the part that separates a fence that stays tight for a decade from one that sags by year two.
Stage 5: Gates, hardware and final walk (day 3, half a day)
Gate frames, hinges, latches and any walk-gate closers get hung and adjusted so they swing clean and latch without a shove. Then we walk the whole line with you. You sign off on the finished fence, we haul off all debris and old material, and your part is done. Most residential jobs wrap inside three working days.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What You’re Choosing Between on a Chain Link Fence
Chain link isn’t one product. The decisions below are the ones that actually change how your fence looks and holds up.
- Gauge (wire thickness): 11.5-gauge is the standard residential fabric and the best balance of price and durability. 9-gauge is heavier and costs meaningfully more, but it resists bending and dents far better if you have dogs or kids leaning on it. 12.5-gauge is the thinnest common option and the cheapest – fine for a temporary or very short run, weak everywhere else.
- Coating: Galvanized steel is the budget baseline. Vinyl-coated (usually green or black) adds cost but handles desert sun and dry air far better and looks less like a chain link fence from the street. In Spring Valley’s UV load, coated fabric outlasts bare galvanized by a wide margin.
- Height: 4-foot is the residential standard and the cheapest per foot. 5-foot and 6-foot step up the post, fabric and concrete cost. If you’re fencing a dog run or a pool area, height and gate type are the first things to settle.
- Gates: A single walk gate is simple and cheap. A double drive gate needs heavier posts and bracing, and the cost jump is real. Decide the gate size before we measure, because gate spacing drives the whole post layout.
- Top rail and tension wire: A full top rail gives the fence a clean top line and better rigidity. A tension wire along the bottom keeps the fabric from lifting. Worth the small added cost on anything longer than a short run.
- Privacy options: Slats, screening or fabric inserts add cost and change the look entirely. Mention it during the estimate if privacy is the goal, because that changes the post spec, not just the add-on.
What Chain Link Fence Costs in Spring Valley, NV

Our lead range for a chain link fence in Spring Valley is $3,500 to $9,000. That covers most standard residential perimeter runs. Where your job lands inside that range comes down to a handful of variables:
- Linear footage: The single biggest driver. A short backyard run sits near the low end; a full perimeter pushes toward the top.
- Caliche and soil conditions: Hard rock under the post line means slower digging and heavier equipment. A site that fights the trencher will land higher than a clean dig, and we tell you that up front rather than mid-job.
- Height and gauge: Moving from a 4-foot 11.5-gauge fence to a 6-foot 9-gauge fence on the same run is a meaningful bump, not a rounding error.
- Gate count and size: Walk gates are modest. Drive gates with heavier posts and bracing add real cost per gate.
- Demo and haul-off: Removing an existing fence, concrete footings and all, is a line item. No old fence, no line item.
- Permit and HOA review: Some Spring Valley lots sit inside a master-planned subdivision with HOA design rules; others don’t. That review takes time and can add a line item, and we’ll tell you which applies to your address.
A written estimate from us lists the footage, the gauge, the coating, the gate count, the concrete and the demo if there is one – line by line. What it doesn’t quietly fold in: utility locate fees if the utility charges one, HOA submission costs, or property-line surveying if the corners aren’t marked and you want them verified. We tell you those separately so nothing appears as a surprise later. The number on the estimate is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Spring Valley Homes Specifically Do to This Job
Spring Valley is unincorporated Clark County, and that fact shapes every fence project here. There’s no city hall issuing a fence permit; all construction permitting runs through Clark County’s Department of Building & Fire Prevention. That means one county process, but a property-line reality that shifts block to block – much of ZIP 89113 has been built out lot by lot along the 215 Beltway and the South Durango corridor rather than in one master plan, so a tract home inside a gated subdivision might sit a short walk from an infill lot under different HOA rules. We pull the plat map and confirm which rules apply to your address before we commit to a layout.
The ground matters just as much. Caliche – the hard calcium-carbonate layer sitting just below the surface across much of the southwest valley – routinely stops a trencher and forces rock-breaking equipment and slower digging. That’s why our estimates budget for it in Spring Valley rather than treating it as an unforeseen extra. Then there’s the heat: summer highs routinely reach 105 to 110°F, so concrete pours and stretch work get scheduled early in the morning and crews work around the sun. Finally, monsoon season brings flash-flooding, which means the fence line needs to account for where water wants to move, not just where the property corner sits. Housing in 89113 runs heavy on 1990s and 2000s stucco-and-tile homes in gated subdivisions, with a newer wave of custom homes and mid-rises – all built to modern code, so the fence typically goes in against clean, straight lines rather than a retrofit fight.
Serving Spring Valley, NV – Our Local Coverage Area
We serve Spring Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Spring Valley

Most residential chain link fences in Spring Valley go in over two to three working days. The build itself is one or two days; the third is usually the utility locate wait, concrete cure, and gate adjustment. A long perimeter or a site that fights caliche can add a day. Call (888) 282-1693 and we’ll give you a realistic window for your specific lot, not a generic one.
Fence permits in Spring Valley run through Clark County, not a city office, and whether your specific project needs one depends on height, location and any HOA rules on your lot. We check the county requirement and the HOA rules for your address before we start, and pull whatever permit applies. Ask us on the estimate call and we’ll tell you exactly what your address requires.
Expect $3,500 to $9,000 for a standard residential run, with the number driven by footage, gauge, coating, gates and soil. A small backyard run sits near the bottom; a full perimeter with a drive gate and demo lands at the top. Call (888) 282-1693 for a written line-item quote – estimates are free and there’s no obligation.
Yes – a chain link fence is a perimeter build and doesn’t touch your house, plumbing or electrical. The only real interaction is buried utilities, and that’s exactly what the 811 locate catches before we dig. If your project is part of a full Fence Installation in Spring Valley plan that includes other fencing later, tell us on the estimate call and we’ll stage it in one visit.
Every chain link fence we build is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right, one of the longest workmanship guarantees in the residential construction space. If a post heaves, a gate sags or fabric pulls loose inside that window, we come back and fix it. Call (888) 282-1693 and we’ll answer any warranty question before you commit.
Get a Free Chain Link Fence Estimate in Spring Valley
When you’re ready to price a chain link fence in Spring Valley, call (888) 282-1693 and a live person answers – any hour, any day. We’ll set up a free on-site walk, measure the run, flag the caliche and utility lines, and put a written line-item estimate in your hands with no change-order surprises. Homeowners often pair this with ADU Site Prep & Utilities in Spring Valley or Door Installation in Spring Valley while we’re on site. For the broader project, see our Fence Installation service and the full Spring Valley coverage area.
Written by the team at Groundwork Construction Co.












