







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Whitney, NV: What to Expect
Concrete driveways & concrete work in Whitney, NV usually run $4,500 – $12,000 for a full driveway installation, and most residential pours are finished in 2 to 4 days once the subgrade is ready. The work covers demolition, grading, forming, rebar or mesh, the pour itself, control joints, and curing. Because Whitney sits under Clark County jurisdiction rather than a city building department, the permit path is different from a Henderson or Las Vegas job. Call (888) 282-1693 for a free on-site estimate.
How We Run a Concrete Job in Whitney, Start to Finish

Every pour follows the same five stages. What changes is the ground under it and the county paperwork.
Day 1: Walkthrough, layout, and permit check
We measure the existing slab or unpaved area, check slope and drainage away from the house, and note what’s buried under it: irrigation lines, gas stubs, old footer remnants. For anything structural or tied to a permit, we pull the Clark County building permit before demolition. This is also when you decide the finish and the thickness (4-inch standard for cars, 5 to 6 inches where an RV or heavy truck parks).
Day 1 – 2: Demolition and haul-off
Old concrete comes out with a breaker and skid steer, then gets hauled to a county-approved disposal site. On infill lots along Boulder Highway, this stage regularly turns up surprises: abandoned septic tanks, old footings from a torn-down structure, or a layer of caliche that has to be broken out. We handle what we find and tell you before it adds cost.
Day 2 – 3: Grading, subgrade, and forms
The base gets graded to a 2% fall away from the house, compacted, and topped with class II base. Forms go in, then rebar or welded wire mesh set on chairs. This is the stage that decides whether the slab cracks in five years or fifteen. Poor compaction on Whitney’s older fill dirt is the number one cause of early failure we see.
Day 3: The pour
In summer, we pour early morning. Mojave heat over 100°F makes concrete set fast, so we add a retarder where needed, use shade or evaporation retardant on the surface, and control joints get cut within 12 to 24 hours. A pour done at 2 p.m. in July is a pour that’s already fighting you.
Day 4 onward: Cure, joints, and seal
Concrete cures for 28 days to full strength, but you can walk on it in 24 hours and drive on it in about 7. We cut control joints, clean up edges, and apply a cure-and-seal coat. A follow-up seal at 6 to 12 months is optional but extends life here given the sun load.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What You’ll Actually Choose Between
Most of the decisions happen before the first shovel. Here’s what matters and what it costs you in real terms:
- Standard broom finish – the default, cheapest, and best grip for a Whitney driveway. Adds nothing to the base bid and holds up to sun and dust well.
- Exposed aggregate – pea gravel surface washed back for texture. Runs about 15 – 25% over broom and shows tire marks less, but it’s rougher on bare feet and harder to shovel.
- 4-inch vs. 5 – 6-inch slab – thicker slab for RV pads, heavy trucks, or where soil is unstable. Adds roughly 20 – 30% to concrete cost but extends life significantly on infill lots with questionable fill.
- Rebar vs. wire mesh – rebar (typically #3 at 18 – 24 inches on center) costs more than mesh but holds slabs together far better through our temperature swings and shrink cracking.
- Control-joint layout – saw-cut joints every 8 to 12 feet in a grid. Done right, cracks happen where you can’t see them. Skipped, they show up across the middle of the slab.
- Sealer – a penetrating or film-forming sealer protects against UV and monsoon moisture. Budget $250 – $700 for a first seal and a re-seal every 3 to 5 years in this climate.
What Concrete Driveways & Concrete Work Costs in Whitney, NV

A full concrete driveway installation in Whitney runs $4,500 – $12,000. A replacement of an existing driveway (demo included) runs $5,000 – $14,000. Sealing a finished slab is $250 – $700. Those are real ranges, not teasers. Here’s what pushes a job from the low end to the high end:
- Square footage and thickness. A single-car 20×20 pad is one job; a three-car plus RV approach at 6 inches is another. Size is the largest single driver.
- Demolition and haul-off. Replacing old concrete adds $800 – $2,500 in removal and disposal. Hauling caliche or old footings adds more.
- Subgrade condition. Stable, compacted base keeps you at the low end. Engineered fill, weak soil, or hidden debris pushes you up.
- Relocating buried utilities. Moving an irrigation line or a gas stub is minor; relocating a sewer cleanout or electrical conduit under the slab is where the number climbs.
- Permit scope. Driveways touching county right-of-way (apron at the street) or tied to a structural change require Clark County permits and inspection. Standalone flatwork on your own lot often doesn’t. We tell you which is which up front.
Every written estimate we hand you is line-itemed: demo, haul-off, base, rebar, concrete, joints, seal, and permit fees separated out. If the number changes after work starts, it’s because we found something in the ground and told you before touching it. No-hassle upfront pricing – the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhy Whitney Jobs Run Differently Than Henderson or Las Vegas
Whitney is unincorporated Clark County – a pocket of 89122 wedged between Las Vegas and Henderson where you can be five minutes from a Henderson address and still be under county jurisdiction. That matters for concrete. Permits get pulled through Clark County, not a municipal building department; inspections are scheduled through the county; and a contractor crossing over from Henderson has to switch permit authorities for a Whitney job. We handle that switch as routine.
The housing stock shapes the work too. Most of Whitney is mid-century to 1970s-80s single-story stucco-and-slab, plus infill subdivisions and manufactured housing pockets filling the remaining lots along Boulder Highway. That means we spend most of our time on teardown-and-replace driveways and slab-on-grade additions rather than clean-slate new construction. Older slabs here often show the classic failure pattern: cracking near the garage apron, settling toward the street, and spalling on the sun-facing side after 30-plus years of desert UV. We also see old fills and former septic footprints on infill parcels that have to be corrected before a new slab goes down.
And the climate runs the schedule. Summer pours go early morning; monsoon season means checking drainage and slope before the season starts, because a low spot that sheds water in April turns into a puddle against the foundation in August. If your project is part of a full Driveway & Pavers in Whitney scope or you’re planning a garage addition, we coordinate the concrete with the rest of the site work.
Serving Whitney, NV – Our Local Coverage Area
We serve Whitney and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Concrete Driveways & Concrete Work in Whitney

Most Whitney driveway pours take 2 to 4 working days from demo to finish, plus about 7 days before you drive on it. Larger jobs with extensive demo or poor subgrade can run 5 to 6 days. Call (888) 282-1693 and we’ll give you a firm schedule after the on-site walkthrough.
It depends on the scope. A standalone driveway or patio slab on your own lot often doesn’t require a permit, but anything touching the county right-of-way – the street apron or sidewalk – or tied to a structural change does. Because Whitney is unincorporated Clark County, permits go through the county, not a city building department. We pull the permits that apply and schedule the inspections.
Usually, yes. Most Whitney driveway replacements leave existing utilities and structures in place because the slab sits in the same footprint. Where a sewer cleanout, gas stub, or irrigation line sits under the new pour, we either protect it in place, sleeve it, or relocate it for a modest added cost – we tell you before we touch it. Call us for an exact quote; estimates are free.
Concrete driveway installation in Whitney runs $4,500 – $12,000, and a replacement with demo included runs $5,000 – $14,000. Sealing is $250 – $700. The biggest drivers are square footage, slab thickness, demo and haul-off, and subgrade condition. Call (888) 282-1693 for a written, line-itemed quote – estimates are free.
Every concrete project we do is backed by the 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship on the pour, joints, and finish, one of the longest workmanship guarantees in residential construction. We put it in writing before we start.
Homeowners in Whitney running a bigger project often pair this with ADU Site Prep & Utilities in Whitney, since driveway grade, drainage, and utility routing all tie together. If you need a new garage entry door or a service door at the same time, we also handle Door Installation in Whitney so the exterior work finishes clean. For a wider look at what we do across Whitney and the surrounding area, see our service-area page, or review our Driveway & Pavers service if you’re weighing concrete against pavers.
Get a Free Concrete Estimate in Whitney
If you’re ready to price a concrete driveway or slab in Whitney, call (888) 282-1693. We’ll schedule a free on-site estimate, walk the ground with you, check slope and utilities, and hand you a line-itemed written quote with the permit path spelled out. Calls are answered by a live person 24/7. From foundation to finish line, we’ve been building across our communities since 2014 – and every job carries the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co. of Boulder City.












